2) In the Settings tab click Load output and set the following info:

3) In the Settings tab click the 3 dots icon and Save settings to file

1a) Connect a 26V power supply to the Victron MPPT and attach the VE. Direct cable to your PC. Open the Victron Connect app on your phone and connect to the device using the default pairing code: 0000000

1b) If the device fails to connect using the default PIN, reset it by clicking the three dots icon next to the device and entering the PUK found on the product label. After resetting, repeat the previous connection step.

2) When prompted, change PIN code to 776824

3) Update SmartSolar Bluetooth Interface if prompted

4) Click the settings gear icon and click the UPDATE button to update FW.

5) Click the settings gear icon and click the 3 dots icon, and select Import settings from file. Then load the settings file and click APPLY.

1) Connect a 26V power supply to the Victron MPPT and attach the VE.Direct cable to your PC. Open the Victron Connect app on the PC and navigate to the device under My Devices.

2) Verify the following Settings in the Status tab:

3) Use DMM to verify voltage across Load+ and Load- is 26V